Roving Networks FIREFLY RN-422 Manuel d'utilisateur télécharger pdf (Page 14)

www.rovingnetworks.com 14

RN-BT-SRL-UM-1.0

APPENDIX B - INSTANT CABLE REPLACEMENT

You can use the Roving Networks adapters (with or without the FirePlug USB dongle, RN-USB-X) for cable replacement

with the following steps:

1. Turn off the adapters and set the switches as shown in Figure 10.

Figure 10. Cable Replacement Switch Settings

! !

2. Power up both devices. The master discovers the slave device, stores its Bluetooth address, and connects. The

devices are now paired and each device’s green LED should be on solid.

3. Set switch 2 on both devices to off so that they do not try to re-pair each time power is cycled. See Figure 11.

Figure 11. Setting Switch 2

Once paired, when the devices are in range of each other, they connect and the master will not attempt to connect to any

other Bluetooth device. To break the pairing, restore the factory defaults using switch 1.

For more information on instant cable replacement, refer to the Bluetooth Cable Replacement Application Note on the

Roving Networks website at http://www.rovingnetworks.com/Support_Overview.

On O

Master Mode

Auto Discovery &

Auto Master Turned On

Slave Mode

Auto Discovery Turned On

On O

Master Mode Slave Mode

1 2 ... 9 10 11 12 13 14 15 16

Pas de commentaire

Roving Networks FIREFLY RN-422 Manuel d'utilisateur Page 14