Roving Networks FIREFLY RN-422 Guide d'installation télécharger pdf

Version 4.16

FirePlug Install Guide

OPERATING MODES

0-Slave Mode - The default mode, whereby other devices can discover and connect to the FirePlug.

1 - Master Mode (SM,1<CR>) Enables outbound connections. To connect, use the “C” command.

2-Trigger Mode (SM,2<CR>) Automatically connects to stored address, when data is received on

local serial port of master.

3-Auto Master Mode (SM,3<CR>) Automatically connects to stored address on power up. If no

address is stored, inquiry is performed until a device is found.

4-DTR Master Mode (SM,4<CR>) Automatically connects to stored address based on the

enabled (active) state of the DTR output signal from PC com port. Automatically disconnects

when DTR is taken away (disabled).

5-ANY Master Mode (SM,5<CR>) Automatically does continuous discovery until it finds a device

to connect to. Does not store any addresses, always picks the first device found (based on

matching the COD set using the SC and SD commands). Uses the DTR signal to initiate discovery,

connect, and disconnect.

NOTE: In all master modes the device will not be discoverable or remote configurable.

LEDs

MODE GREEN LED BLINK

Configuring Fast, 10 x per second

Boot up, Remote Configurable 2 times per second

Discoverable/Idle 1 time per second

Connected On Solid

The YELLOW Led blinks when data is TRANSMITTED or RECEIVED.

Initial Setup

Just plug the FirePlug into any USB port, on Windows, Apple MAC, or Linux PC. Fireplug uses the

FTDI 232RL chip, drivers for this are built in on MAC OS and Linux, and some Windows XP

machines. If not, the PC can automatically search and install the required drivers. Once the driver

installs, you can check what COM port was installed by Using the Device Manager under

Windows. Look under the Ports( COM & LPT) section and you should find a COM port with the

name “USB Serial Port”.

Baudrate

The FirePlug defaults to 115200, no parity, 8 bits, 1 stop. Because data is actually flowing back

and forth over a VIRTUAL COM via the USB port, there generally is no need to change this.

However, some older programs require other baudrates or parity settings. If required, the FirePlug

can be changed to these settings, then rebooted and the new settings will take effect.

1 2 3 4

Résumé du contenu

Page 1 - FirePlug Install Guide

Version 4.16 FirePlug Install Guide OPERATING MODES 0-Slave Mode - The default mode, whereby other devices can discover and connect to the FireP

Page 2 - Changing Configuration

Roving Networks FirePlug-II V 4.00 1/31/2007 page 2 Making a Connection FirePlug shows up under Service di

Page 3 -

Roving Networks FirePlug-II V 4.00 1/31/2007 page 6 COMMON PROBLEMS and QUESTIONS: My Bluetooth client can

Page 4 - NOTES ON OPERATION:

Roving Networks FirePlug-II V 4.00 1/31/2007 page 4 NOTES ON OPERATION: Master Modes: There are 5 differen

Commentaires sur ces manuels

Pas de commentaire

Roving Networks FIREFLY RN-422 Guide d'installation

Naviguer en ligne ou télécharger Guide d'installation pour Non Roving Networks FIREFLY RN-422. Roving Networks FIREFLY RN-422 Install guide Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels