Roving Networks WIFLY GSX Guide de l'utilisateur télécharger pdf (Page 37)

RN-WIFLYCR-UG

www.rovingnetworks.com Version 1.2r 4/30/13 page 37

2.4.14 ver

The command displays the firmware version.

Example: ver // Show the firmware version

2.5 STATUS COMMANDS

These commands begin with the keyword show and they return the current values of

the system variables. In some cases, e.g., IP addresses, the current values are

received from the network and may not match the stored values. Except where noted,

the show commands do not have any parameters.

2.5.1 show battery

This command displays current battery voltage, and is only applicable to Roving

Networks’ battery-powered products such as the RN370 and temperature sensors

(ISENSOR-CB).

Example: show battery // Show the current battery voltage

2.5.2 show connection

This command displays the connection status in the hex format 8<XYZ>, where

8<XYZ> is a bit-mapped register providing the information shown in Figure 2-8.

FIGURE 2-8: SHOW CONNECTION COMMAND BIT-MAPPED REGISTER

2.5.3 show io

This command displays the GPIO pins’ level status in the hex format 8<ABC>. For

example, 8103 indicates GPIO 0, 1, and 8 are high.

Example: show io // Show the GPIO level status

2.5.4 show net <char>

The command displays the current network status, association, authentication, etc.,

where <char> is the optional parameter n. Using the n parameter displays only the

MAC address of the access point with which the module is currently associated.

Example: show net n // Show the access point’s MAC address

4567 3..0

TCP status. 0 = idle; 1 = connected; 3 = No IP; 4 = connecting

Association. 1 = OK.

Authentication. 1 = OK.

DNS server. 1 = server is contacted.

DNS found. 1 = DNS is resolved.

12..9

Channel. Value = 1 - 13.

16..13

Fixed. Value = 8.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 121 122

Pas de commentaire

Roving Networks WIFLY GSX Guide de l'utilisateur Page 37