Roving Networks WIFLY GSX Guide de l'utilisateur télécharger pdf (Page 68)

RN-WIFLYCR-UG

www.rovingnetworks.com Version 1.2r 4/30/13 page 68

Use the show time command to see the current time and uptime as shown below:

<2.23> show t

Time=08:43:10

UpTime=10 s

To set the time, use the time command:

<2. 23> show t

Time NOT SET

UpTime=8 s

<2. 23> time

<2. 23> show t

Time=08:51:31

UpTime=15 s

The module can also be configured to get the time whenever it powers up using the set

time enable 1 command. If you set the time enable to a value greater than 1, the mod-

ule pulls the time continuously every <value> minutes.

For example, to configure the module to get time upon power up, see the following

example:

<2. 23> set time enable 1

AOK

<2. 23> get time

ENA=1

ADDR=129.6.15.28:123

ZONE=7

To view a complete listing of the time variable, use the following command:

<2. 23> show t t

Time=09:02:10

UpTime=653 s

RTC=1293567548

Restarts=1

Wake=6

RAW=2345ab

Note: The module must be associated with a network for the module to contact

the sNTP server.

Note: The RAW value is the 64-bit hex RAW value of the RTC, which ticks at

32,768 Hz.

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 121 122

Pas de commentaire

Roving Networks WIFLY GSX Guide de l'utilisateur Page 68